Polishing:
Polishing will be uniform throughout the slabs/tiles and in gloss meter as:
For black slabs / tiles: polishing +95 in gloss meter
For colored slabs/ tiles: polishing +85 in gloss meter
There should be no grinding wheel marks on the polished face
Flaming:
Flaming will be uniform throughout the slabs/tiles and brushed evenly on slabs after flaming
Thickness:
+/-1.0mm in tolerance for slabs
+/-0.5mm in tolerance for tiles
Diagonal Out:
+/- 0.5mm in tolerance for tiles
Flatness:
If length <= 400mm, flatness tolerance: +/-0.2mm
If 400mm < length < 1000, flatness tolerance: +/- 0.5mm
If length >= 1000mm, tolerance: +/- 0.8mm
Length and Width:
+/- 0.5mm in tolerance for tiles and slabs (not apply to the random edge slabs).
Front Edge Defect:
Not allowed for slabs and tiles.
Front Corner Defect:
Not allowed for slabs and tiles
Unpolished Side:
The unpolished side of the slab/tiles should be flat and smooth.
Crack:
Not allowed for slabs and tiles.
Crack Looks Treatment:
If slab/tile have crack looks (not the real crack, like paper was foddered but not tear down), please treat it.
Surface Treatment:
If it is possible, treat the slab/tile surface after it has been polished. So there is no little dent. This treatment is not required, but is recommended.
Billed Area Defamation:
For slab size > 1.2m x 2.2m, there should be a 1" (2.54 CM) allowance on each side of the slab to be taken out for the actually billed area.
Contact:
Phone: 0086-18159884921
Tel: 0086-592-7628325
Email: info@infinite-gm.com
Add: No. 1515, Xinao Road, Xiangan District, Xiamen, China